Computational fluid dynamics (CFD) is becoming an increasingly popular tool in the wave energy sector, and over the last five years we have seen many studies using CFD. While the focus of the CFD studies have been on the validation phase, comparing numerically obtained results against experimental tests, the uncertainties associated with the numerical solution has so far been more or less overlooked. There is a need to increase the reliability of the numerical solutions in order to perform simulation based optimization at early stages of development. In this paper we introduce a well-established verification and validation (V&V) technique. We focus on the solution verification stage and how to estimate spatial discretization errors for simulations where no exact solutions are available. The technique is applied to the cases of a 2D heaving box and a 3D moored cylinder. The uncertainties are typically acceptable with a few percent for the 2D box, while the 3D cylinder case show double digit uncertainties. The uncertainties are discussed with regard to physical features of the flow and numerical techniques.
The present paper describes the work carried out in the project ’Mooring Solutions for Large Wave Energy Converters’, which is a Danish research project carried out in a period of three years from September 2014, with the aim of reducing cost of the moorings for four wave energy converters and improving the applied design procedure. The paper presents the initial layouts and costs and illustrates which solutions could potentially reduce cost. Different methods for analysis of the systems were applied, ranging from simple quasi-static analysis to full dynamic analysis and experimental work. The numerical methods were compared to the experimental data, and results showed significant underestimation of tensions in the quasi-static model while reasonable overestimation was found in the dynamic analysis even without major tuning of the model. The dynamic analysis has then been implemented in a meta-model based optimization process with the aim of optimizing the mooring layout for each WEC according to cost of the systems.
An increasing water to oil ration in the North Sea oil and gas production motivates for an optimization of the current deoiling facilities. Current facilities are operated on matured methodologies, which in most cases fulfill the government regulations. However, it has also observed that these solutions could be further improved. In order to more precisely monitor the deoiling operations, this study investigated the real-time monitoring of the deoiling efficiency of the hydrocyclone facilities which are commonly used in offshore oil and gas production. Fluorescence based monitors were applied to measure hydrocyclone inlet's and underflow's Oil-in-Water (OiW) concentrations in real-time. Image-based microscopy was used to analyze the oil droplet size distribution at inlet and underflow to investigate the droplets' influence on hydrocyclone's efficiency. Performance experiments were carried out to identify how pressure difference ratio (PDR) and the droplet's sizes affect the deoiling efficiency. The performance of the deoiling hydrocyclone was significantly influenced by the inlet flow rate, while less or marginally dependent on the PDR. The droplet size distribution experiment proved that large droplets have a high probability to be separated by the hydrocyclone. The findings suggest that the coupled separator tank and hydrocyclone system can be further improved upon by deploying coordinated control as the two systems are strongly interdependent.
This article examines the rise of maritime security in concept and practice. We argue that developments in the maritime arena have flown beneath the radar of much mainstream international relations and security studies scholarship, and that a new agenda for maritime security studies is required. In this article we outline the contours of such an agenda, with the intention of providing orientation and direction for future research. Our discussion is structured into three main sections, each of which outlines a core dimension of the maritime security problem space. We begin with a discussion of the issues and themes that comprise the maritime security agenda, including how it has been theorized in security studies to date. Our argument is that the marine environment needs to be understood as part of an interlinked security complex, which also incorporates strong connections between land and sea. Second, we examine the ways in which maritime security actors have responded to these challenges in practice, focusing on issues of maritime domain awareness, coordination of action, and operations in the field. Third, we turn to the mechanisms through which the new maritime security agenda is being disseminated to local actors through a process of devolved security governance. We focus particularly on efforts to distribute knowledge and skills to local actors through capacity building and security sector reform. In the conclusion, we outline the future challenges for maritime security studies that follow from these observations.
The present numerical study aims to assess the performance of an Eulerian Stochastic Field (ESF) model in simulating spray flames produced by three fuel injectors with different nozzle diameters of 100 µm, 180 µm and 363 µm. A comparison to the measurements shows that although the simulated ignition delay times are consistently overestimated, the relative differences remain below 28%. Furthermore, the change of the averaged pressure rise with respect to the variation of nozzle diameter is captured by the model. The simulated flame lift-off lengths also agree with the measurements, with a maximum relative difference of 13%. The spray flame produced by a larger nozzle diameter has a fuel-richer premixed core region despite the longer lift-of length, indicating that the higher fueling rate used with the larger nozzle diameter is a more dominating factor than the lift-off length is in influencing the air entrainment into the upstream of the spray flames. In addition, the simulated normalised flame lengths are found to decrease when the nozzle diameters increase. These predictions are in good qualitative agreement with the experimental observation. This work proves that the ESF model can serve as an important tool for the simulation of spray flames in marine diesel engines, where fuel injectors with different nozzle diameters are applied for pilot and main injections.
Corrosive wear of cylinder liners in large two-stroke marine diesel engines that burn heavy fuel oil containing sulfur is coupled to the formation of gaseous sulfur trioxide (SO3) and subsequent combined condensation of sulfuric acid (H2SO4) and water (H2O) vapor. The present work seeks to address how fuel sulfur content, charge air humidity and liner temperature variations affects the deposition of water and sulfuric acid at low load operation. A phenomenological engine model is applied to simulate the formation of cylinder/bulk gas combustion products and dew points comply with H2O–H2SO4 vapor liquid equilibrium. By assuming homogenous cylinder gas mixtures condensation is modeled using a convective heat and mass transfer analogy combined with realistic liner temperature profiles. Condensation of water is significantly altered by the liner temperature and charge air humidity while sulfuric acid condensation (the order is a few mg per cylinder every cycle) is proportional to the fuel sulfur content. Condensation takes place primarily in the upper part of the cylinder liner where a reduction of the surface temperature or saturated charge air provides that the deposited acid can be highly diluted with water.
This article gives a review of techniques applied to make sea state estimation on the basis of measured responses on a ship. The general concept of the procedures is similar to that of a classical wave buoy, which exploits a linear assumption between waves and the associated motions. In the frequency domain, this assumption yields the mathematical relation between the measured motion spectra and the directional wave spectrum. The analogy between a buoy and a ship is clear, and the author has worked on this wave buoy analogy for about fifteen years. In the article, available techniques for shipboard sea state estimation are addressed, but with a focus on only the wave buoy analogy. Most of the existing work is based on methods established in the frequency domain but, to counteract disadvantages of the frequency-domain procedures, newer studies are working also on procedures formulated directly in the time domain. Sample results from several studies are included, and the main findings from these are mentioned.
The international Maritime Organization (IMO) Weather Criterion has proven to be the governing stability criteria regarding minimum metacentric height for e.g., small ferries and large passenger ships. The formulation of the Weather Criterion is based on some empirical relations derived many years ago for vessels not necessarily representative for current new buildings with large superstructures. Thus, it seems reasonable to investigate the possibility of capsizing in beam sea under the joint action of waves and wind using direct time domain simulations. This has already been done in several studies. Here, it is combined with the first order reliability method (FORM) to define possible combined critical wave and wind scenarios leading to capsize and corresponding probability of capsize. The FORM results for a fictitious vessel are compared with Monte Carlo simulations, and good agreement is found at a much lesser computational effort. Finally, the results for an existing small ferry will be discussed in the light of the current weather criterion.
The purpose of this paper is to investigate a multiple ship routing and speed optimization problem under time, cost and environmental objectives. A branch and price algorithm as well as a constraint programming model are developed that consider (a) fuel consumption as a function of payload, (b) fuel price as an explicit input, (c) freight rate as an input, and (d) in-transit cargo inventory costs. The alternative objective functions are minimum total trip duration, minimum total cost and minimum emissions. Computational experience with the algorithm is reported on a variety of scenarios.
The European fisheries management is currently undergoing a fundamental change in the handling of catches of commercial fisheries with the implementation of the 2013 Common Fisheries Policy. One of the main objectives of the policy is to end the practice of discarding in the EU by 2019. However, for such changes to be successful, it is vital to ensure stakeholders acceptance, and it is prudent to consider possible means to verify compliance with the new regulation. Remote Electronic Monitoring (REM) with Closed-Circuit Television (CCTV) has been tested in a variety of fisheries worldwide for different purposes and is currently considered as one possible tool to ensure compliance with a European ban on discards.
This study focuses on Danish fishery inspectors and on fishers with REM experience, whose opinions are less well known. Their views on the landing obligation and on the use of REM were investigated using interviews and questionnaires, and contrasted to some fishers without REM experience. 80% of fishery inspectors and 58% of REM-experienced fishers expressed positive views on REM. 9 out of 10 interviewed fishers without REM experience were against REM. Participation in a REM trial has not led to antipathy towards REM. Fishery inspectors saw on-board observers, at-sea control and REM as the three best solutions to control the landing obligation but shared the general belief that the landing obligation cannot be enforced properly and will be difficult for fishers to comply with. The strengths and weaknesses of REM in this context are discussed.