A computational fluid dynamics study of the scavenging process in a large two-stroke marine engine is presented in this work. Scavenging which is one of the key processes in the two-stroke marine engines, has a direct effect on fuel economy and emissions. This process is responsible for fresh air delivery, removing the combustion products from the cylinder, cooling the combustion chamber surfaces and providing a swirling flow for better air-fuel mixing. Therefore, having a better understanding of this process and the associated flow pattern is crucial. This is not achievable solely by experimental tests for large engines during engine operation due to the difficulties of measuring the flow field inside the cylinder. In this study, the axial and tangential velocities are compared and validated with the experimental results obtained from Particle Image Velocimetry (PIV) tests [1]. The simulations are conducted using both Unsteady Reynolds Averaged Navier Stokes (URANS) and Large Eddy Simulation (LES) turbulence models. We observe in general, there is a good agreement between the numerical and experimental results. The flow inside the cylinder is studied in different locations related to the bottom of the scavenging ports during the period with open exhaust valve. Moreover, the replacement of combustion products with fresh scavenge air is analysed. The effective flow angle is calculated for the air flow through the scavenging ports. It is found that the effective flow angle is different from the geometrical angle of the ports (20°). Results illustrate better performance of LES, especially in the prediction of the tangential velocity which is crucial for the simulation of an accurate swirl and air-fuel mixing inside the marine engines. LES predicts a uniform profile for the tangential velocity at the top of cylinder which is consistent with the experimental results while URANS predicts a solid body rotation.
The purpose of this paper is to assess the status and prospects of the decarbonization of maritime transport. Already more than two years have passed since the landmark decision of the International Maritime Organization (IMO) in April 2018, which entailed ambitious targets to reduce greenhouse gas (GHG) emissions from ships. The paper attempts to address the following three questions: (a) where do we stand with respect to GHG emissions from ships, (b) how is the Initial IMO Strategy progressing, and (c) what should be done to move ahead? To that effect, our methodology includes commenting on some of the key issues addressed by the recently released 4th IMO GHG study, assessing progress at the IMO since 2018, and finally identifying other issues that we consider relevant and important as regards maritime GHG emissions, such as for instance the role of the European Green Deal and how this may interact with the IMO process. Even though the approach of the paper is to a significant extent qualitative, some key quantitative and modelling aspects are considered as well. On the basis of our analysis, our main conjecture is that there is not yet light at the end of the tunnel with respect to decarbonizing maritime transport.
The power system of an all-electric ship (AES) establishes an independent microgrid using the distributed energy resources, energy storage devices, and power electronic converters. As a hybrid energy system (HES), the power system of an AES works as a unified system where each part can affect the reliability of the other parts. The systemic reliability centered maintenance (SRCM), which efficiently enhances the reliability and safety of the AES by identifying optimal maintenance tasks of the AES, is considered in this article to apply to the entire system. In order to calculate the reliability and optimal maintenance schedule, the Markov process and Enhanced JAYA (EJAYA) are utilized. A layer of protection analysis (LOPA), which is a risk management technique, is adopted to assess the safety of the system. A hybrid molten carbonate fuel cell, photovoltaic (PV), and lithium-ion battery are considered as energy sources of the AES. Based on two common standards, DNVGL-ST-0033 and DNVGL-ST-0373, the suggested maintenance planning method can be used in industrial applications. Eventually, in order to validate the proposed method, a model-in-the-loop real-time simulation using dSPACE is carried out. The obtained results show the applicability and efficiency of the proposed method for improving reliability and safety.
The power to regulate on-board protection of merchant vessels lies with the flag state. However, the national models of regulation are not developed in a unilateral vacuum. In fact, the whole concept of flag state jurisdiction and legislative power has to be understood and exercised on the national level in close relation with the general regime of the international law of the sea. The aim of the article is therefore two-fold: first, it aims to provide a background for the country reports in this special issue by giving a brief insight into the problem of piracy in the twenty-first century and the international approaches towards this problem. Here the article also provides an insight into the legal background by presenting the concept of piracy in the law of the sea and connected law enforcement powers. Thus, this part of the article provides the overall context in which the discussions concerning on-board protection and the development of national regulations have occurred. Second, the article analyses the issue of on-board protection from the perspective of the legal framework in international law, as well as relevant international soft-law instruments, influencing the development on the national level. On-board protection of vessels as such is not regulated in the international law; however, international law provides a form of general legal setting, in which flags states navigate. Thus, this article aims to draw a picture of the international context in which flags states develop their specific legal approach.
We present a depth-integrated Boussinesq model for the efficient simulation of nonlinear wave–body interaction. The model exploits a ‘unified’ Boussinesq framework, i.e. the fluid under the body is also treated with the depth-integrated approach. The unified Boussinesq approach was initially proposed by Jiang (2001) and recently analyzed by Lannes (2017). The choice of Boussinesq-type equations removes the vertical dimension of the problem, resulting in a wave–body model with adequate precision for weakly nonlinear and dispersive waves expressed in horizontal dimensions only. The framework involves the coupling of two different domains with different flow characteristics. Inside each domain, the continuous spectral/hp element method is used to solve the appropriate flow model since it allows to achieve high-order, possibly exponential, convergence for non-breaking waves. Flux-based conditions for the domain coupling are used, following the recipes provided by the discontinuous Galerkin framework. The main contribution of this work is the inclusion of floating surface-piercing bodies in the conventional depth-integrated Boussinesq framework and the use of a spectral/hp element method for high-order accurate numerical discretization in space. The model is verified using manufactured solutions and validated against published results for wave–body interaction. The model is shown to have excellent accuracy and is relevant for applications of waves interacting with wave energy devices.
Mooring systems for floating wave energy converters often rely on floaters to allow for minimum restraints of the body motion in heavy. However, the inclusion of floaters also introduce possible slack-taut scenarios induced by the dynamic response of the floater in relation to the fair-lead point of the mooring. This can increase the occurrence of snap loads. The present study outlines the work to include floaters and sinks into a high-order discontinuous Galerkin model for mooring cable dynamics. Numerical simulations of a mooring leg adapted from the Waves4Power full-scale device are performed, and the results from varying the floater geometry are analyzed.
For this case the floater influence on the occurrence of snap loads was clearly evident. There is a strong correlation between floater pitch response and cable slack in the upper mooring cable. For a floater with constant buoyancy, increasing the floater height and thereby increasing the pitch inertia of the floater is shown to decrease the range of frequencies where cable slack occurs. It is illustrated that for some cases, changing floater geometry can avoid slack altogether. A careful design of the floater geometry can thus make a large difference for the dynamic load factor of the mooring system.
We present a high-order nodal spectral element method for the two-dimensional simulation of nonlinear water waves. The model is based on the mixed Eulerian–Lagrangian (MEL) method. Wave interaction with fixed truncated structures is handled using unstructured meshes consisting of high-order iso-parametric quadrilateral/triangular elements to represent the body surfaces as well as the free surface elevation. A numerical eigenvalue analysis highlights that using a thin top layer of quadrilateral elements circumvents the general instability problem associated with the use of asymmetric mesh topology.We demonstrate how to obtain a robust MEL scheme for highly nonlinear waves using an efficient combination of (i) global L2 projection without quadrature errors, (ii) mild modal filtering and (iii) a combination of local and global re-meshing techniques. Numerical experiments for strongly nonlinear waves are presented. The experiments demonstrate that the spectral element model provides excellent accuracy in prediction of nonlinear and dispersive wave propagation. The model is also shown to accurately capture the interaction between solitary waves and fixed submerged and surface-piercing bodies. The wave motion and the wave-induced loads compare well to experimental and computational results from the literature.
Maritime medicine deals with the health of seafarers, fishermen, and offshore employees and, more specifically, with their employment, working and living conditions, and their health and safety at sea. Maritime doctors should have the appropriate training and competencies to provide the equivalent service as would be found on land. This review discusses a) the required skills and competencies of maritime doctors and b) explores the associated ongoing discussions for the establishment of a global accredited Masters programme in maritime health. A literature review was conducted using 2 databases: PubMed and Google scholar. Search terms included: maritime doctors, maritime medicine, occupational health, and skills and competencies. Literature published between 1990 and 2018 was prioritised. Thirty-five articles that discussed the skills, competencies, and education of maritime doctors and health professionals were retrieved, reviewed, and discussed, plus 8 reports and documents from relevant International Organisations webpages. We explored policies in relation to training using i) the health triangle and ii) the Kingdon model. Doctors who serve in the sector should have extensive knowledge about medical practice, but also about the environment of seafaring. The complexity of their roles, coupled with the provision of a high quality of services in global shipping, call for high quality accredited training and harmonisation of maritime health practices. The analysis of policy, using 2 policy models, showed that a window of opportunity appears to be in favour of a policy regarding the recognition of maritime medicine as a medical specialisation. International stakeholders, together with the International Maritime Health Association, should actively advocate such a perspective which will be in favour of seafarers, who will enjoy better health and wellbeing, with higher income while avoiding ill-health, as well as the shipping industry, which will employ satisfied and loyal employees, and will enjoy a higher reputation.
This paper describes the methodological aspects of calculation of incidence rates from incomplete data in occupational epidemiology. Proportionate measures in epidemiological studies are useful e.g. to describe the proportion of slips, trips and falls compared to other types of injury mechanisms within single age-strata. However, a comparison of proportions of slips, trips and falls among the different age-strata gives no meaning and can hamper the conclusions. Examples of a constructed example and some selected studies show how estimates of incidence rates can be calculated from the proportionate data by applying estimates of denominators available from other information. The calculated examples show how the risks based on the incidence rates in some cases differ from the risks based on the proportionate rates with the consequence of hampering the conclusions and the recommendations for prevention. In some cases the proportionate rates give good estimates of the incidence rates, but in other studies this might cause errors. It is recommended that estimates of the incidence rates should be used, where this is possible, by estimation of the size of the population. The paper is intended to be useful for students and teachers in epidemiology by using the attached Excel training file.
The maritime industry is a dangerous and highly technologicallysaturated sector. Unfortunately, advancement in automation and technologyhave not minimised human error as intended. Interaction between humansand technology in the industry is also overtly pre-scripted. The main reasonfor this is to reduce human error by ensuring predictability in interaction.Ultimately, investigations of non-routine interaction are often based on a hind-sight view of what went wrong in a given situation. This article analyses acollection of non-routine interactions that derive from a larger data corpus,using Discursive Psychology and Conversation Analysis. It argues that such astudy can capture what is missing from some investigations, namely, whatmakes sense for crews in the context of a given non-routine situation. Despitethe constraints and the challenges of technological complexity, this articleargues that reframing psychological matters in non-routine technologicallymediated interaction can be a new way of showing how such matters aredynamic, visible and manageable. This can inform the general debate of howto minimise human error, and more specifically, provide insight into the increas-ing inclusion of technology and as a consequence, the equally increasingamount of technologically mediated interaction that we will see in the future.