In this paper, a novel configuration of a pumped thermal electricity storage system is proposed which can integrate excess thermal energy from different renewable thermal energy sources, e.g. concentrated solar power, waste heat and deep geothermal energy plants, as well as excess electricity from direct electricity generating renewable energy sources, e.g. solar photovoltaic and wind energy plants. The proposed configuration can also be used as a retrofit option to existing conventional fossil fuel-based power plants. A conventional two-tank sensible heat storage is used as a thermal energy storage system that can be charged using direct renewable thermal energy and using a heat pump utilizing excess electricity. Different discharging cycles, including a Joule–Brayton system and a conventional steam Rankine cycle system, can be used. The proposed system can achieve a higher capacity factor compared to those of stand-alone plants.
As a case study, a conventional two-tank molten salt-based thermal energy storage system integrating concentrated solar power, considering a heliostat system, and a solar photovoltaic plant is investigated. The overall operational strategy of the plant was developed and based on that annual simulations were performed for a selected configuration. The results of the case study suggest that for a given requirement of capacity factor, the final selection of the capacities of the solar photovoltaic plant, heat pump and heliostat field should be done based on the minimum levelized cost of energy. Moreover, for high capacity factor requirements, the proposed configuration is promising.
Solid-state lithium battery (SSLB) is considered as the most potential energy storage device in the next generation energy system due to its excellent safety performance. However, there are still intimidating safety issues for the SSLB, due to it being still in the development stage. This paper gives an overview of the safety of SSLBs. First, advanced solid-state battery techniques are introduced. Second, the safety issues of SSLBs are discussed. Then, the safety enhancement techniques are provided. Finally, future research opportunities are presented. This paper aims to provide a reference for researchers in the fields of electronic and electrical engineering who want to make some efforts in SSLB safety.
Rumor has it that all technologies needed to build energy islands are ready. Wind turbines are spinning in many large offshore parks, while combinations of sand and concrete have given birth to several entirely new islands. However, not all rumors are true. Not only has the Danish parliament mandated the largest ever infrastructure project in the history of our country. The first Danish artificial island built for energy production will also become the world’s largest renewable energy project. On top of the technical and logistical challenges associated with building something of an unprecedented scale and nature come new concerns. The energy islands are an extreme version of the power system we know today, and therefore represent a Mars mission for the energy system. More than once have large infrastructure projects been plagued by delays and significant additional costs. Often such problems have been rooted in overly optimistic planning, limited knowledge regarding the complexity and interdependencies involved, and not giving enough attention to the development phase relative to the construction phase. For many reasons, it is highly desirable for the energy island projects to perform well. Therefore, we have teamed up to map the key challenges and suggest R&D initiatives to address them. Importantly, these initiatives are not intended as an inserted step before construction. Given the urgency in green transition and ending the reliance on fossil fuels, research and construction must be conducted in parallel. A solid foundation for energy islands On the following pages we invite you to delve into the complexity of constructing and operating offshore hubs for renewable energy. As you will hopefully agree, we are by no means saying that it cannot be done. It can. But only if decisions are based on a solid foundation of knowledge.
In this study, we investigate the barriers and enablers companies face when they seek to establish a fully decarbonized supply chain from the ground up. While recent research on sustainable supply chain management has advanced our understanding of how existing supply chains can become more sustainable, there is less research on fully decarbonized supply chains that are designed carbon neutral to produce carbon neutral products. This research aims to expand that frontier by investigating the case of the emerging supply chain delivering fossil-neutral e- methanol to the shipping industry.
A new motivation for marine restoration has been observed, associated with the dissatisfaction with current marine restoration governance arrangements (MRGAs). An MRGA consists of alliances of public and private actors (coalitions) who, through their common conceptualisation of the problem (discourses), try to influence and design marine restoration activities while considering the rules of decision-making, and the management of limited resources. Emerging MRGAs rise in parallel to existing ones and aim to contribute to the same goals or show another way of reaching those goals. This phenomenon raises questions of legitimacy both for the emerging and the existing arrangement. Building on existing literature, this paper proposes an analytical framework to simultaneously explore input, throughput and output legitimacy as three essential pre-conditions of legitimacy for MRGAs. The framework is tested in three European cases of MRGAs that were part of the European Union MERCES project (http://www.merces-project.eu/). Analysis showed that actors who are influential in achieving restoration goals, and also those who are impacted by restoration actions, should be involved in the MRGAs (input legitimacy); actors within MRGAs should establish and follow procedures for decision-making that are both transparent and clear (throughput legitimacy); and actors within MRGAs need to establish a common understanding of restoration, of the goal to reach and of the related uncertainties (output legitimacy). Awareness of these pre-conditions allows actors internal and external to MRGAs to address aspects that give legitimacy to restoration actions. It also creates a language that allows actors to engage in discussion on legitimacy that goes beyond the mere application of the rule of law.
The increasing role of offshore wind power plants in the electricity generation mix in Turkey raises some critical grid operation issues. In this context, the grid code regulation concerning the penetration of large-scale offshore wind power plants into Turkey's power system has become a prominent factor in the development of a reliable grid operation. In this paper, a comprehensive benchmark for grid codes of the European countries that have large-scale offshore wind power plants and Turkey is performed by considering voltage regulation, frequency regulation, fault ride-through, and power quality features. The compatibility of the grid codes in terms of the minimum technical requirements is discussed to show the pros and cons. An elaborate assessment of the Turkish grid code reveals the technical properties that need to be improved. The rigorous state-of-the-art review indicates that active power control & frequency regulation, reactive power control & voltage regulation, and voltage ride-through capabilities should be clarified in detail for the Turkish grid code. With this background, various recommendations, key challenges, and future trends related to the improvement of technical requirements for the Turkish grid code for the integration of offshore wind power plants are highlighted to help researchers, plant owners, and system operators.
1. Introduction. 2. Industry self-regulation in maritime law. 2.1. Why is industry self-regulation necessary? 2.2. Relevant self-regulatory instru- ments. 3. Industry self-regulation and armed protection. 3.1. Quality assurance of private Maritime Security Companies. 3.2. Use of force. 3.3. Reporting. 4. Remarks and conclusion
Cyber-resilience is an increasing concern for autonomous navigation of marine vessels. This paper scrutinizes cyber-resilience properties of marine navigation through a prism with three edges: multiple sensor information fusion, diagnosis of not-normal behaviours, and change detection. It proposes a two-stage estimator for diagnosis and mitigation of sensor signals used for coastal navigation. Developing a Likelihood Field approach, the first stage extracts shoreline features from radar and matches them to the electronic navigation chart. The second stage associates buoy and beacon features from the radar with chart information. Using real data logged at sea tests combined with simulated spoofing, the paper verifies the ability to timely diagnose and isolate an attempt to compromise position measurements. A new approach is suggested for high level processing of received data to evaluate their consistency, which is agnostic to the underlying technology of the individual sensory input. A combined generalized likelihood ratio test using both parametric Gaussian modelling and Kernel Density Estimation is suggested and compared with a detector using only either of two. The paper shows how the detection of deviations from nominal behaviour is possible when the navigation sensor is under attack or defects occur.
Digital Twins have much attention in the shipping industry, attempting to support all phases of a vessel’s life cycle. With several tools appearing in Digital Twin software suites, high-quality manoeuvring and performance prediction remain cornerstones. Propulsion efficiency is in focus while in service. Simulator-based training is in focus to ensure safety of manoeuvring in confined waters and harbours. Prediction of ships’ velocity and turn rate are essential for correct look and feel during training, but phenomena like dynamic inflow to propellers, bank and shallow water effects limit simulators’ accuracy, and master mariners often comment that simulations could be in better agreement with actual behaviours of their vessel. This paper focuses on digital twin enhancements to better match reality. Using data logged during in-service operation, we first consider a system identification perspective, employing a first-principles model structure. Showing that a complete firstprinciples model is not identifiable under the excitation met in service, we employ a Recurrent Neural Network to predict deviations between measured velocities and the model output. The outcome is a hybrid of a first-principles model with a machine learning generic approximator add-on. The paper demonstrates significant improvements in prediction accuracy of both in-harbour manoeuvring and shallow water passage conditions.
Marine autonomy research has focused on algorithmic and technical developments, targeting autonomous craft in restricted areas where international rules and regulations are not prioritised. This paper addresses the system engineering aspect of a highly complex system in which the seamless, predictable, and secure interoperability of vendorspecific hardware and software subsystems is a fundamental requirement for designing and implementing cyber-physical systems with artificial intelligence to assist or replace the navigating officer, such as autonomous marine surface vehicles. It addresses international rules in the sector and exhibits a system architecture that can fulfil the criteria for safe behaviour in foreseen occurrences and the capacity to request human aid if the autonomous system cannot manage a problem. The system thinking and engineering provided in this article have been applied to The GreenHopper, a harbour bus currently under construction and intended to undergo certification and enter commercial service.