Green House Gas (GHG) emissions are not the only emissions of concern to the international transport community. SOx emissions are non-GHG emissions that are caused by the presence of sulphur in the fuel. As the maximum percentage of sulphur in automotive and aviation fuels is strictly regulated in most countries around the world, much of the attention in recent years has focused on maritime transport. The attention mainly stems from the fact that in marine fuels the percentage of sulphur can be very high: it can be as high as 4.5 % in Heavy Fuel Oil (HFO), which is the fuel typically used in all deep-sea trades. Even though the amounts of SOx produced by ships are substantially lower than CO2, SOx emissions are highly undesirable as they cause acid rain and undesirable health effects in humans and animals. To mitigate these adverse environmental effects, the international shipping community has taken substantial policy measures. With the introduction of new limits for the content of sulphur in marine fuels in Northern European and North American sea areas, short-sea companies operating in these areas will face substantial additional cost. As of 1/1/2015, international regulations stipulate, among other things, a 0.1%limit in the sulphur content of marine fuels, or equivalent measures limiting the percent of SOx emissions to the same amount. As low-sulphur fuel is substantially more expensive than HFO, there is little or no room within these companies current margins to absorb such additional cost, and thus significant price increases must be expected. Unlike its deep-sea counterpart, in short-sea shipping such a freight rate increase may induce shippers to use landbased alternatives (mainly road). A reverse shift of cargo would go against the EU policy to shift traffic from land to sea to reduce congestion, and might ultimately (under certain circumstances) increase the overall level of CO2 emissions along the entire supply chain. The purpose of this chapter is to investigate the potential effect of sulphur regulations on the share of cargo transported by the waterborne mode vis-à-vis land-based alternatives.
A fuel levy is one of the market-based measures (MBMs) currently under consideration at the International Maritime Organization. MBMs have been proposed to improve the energy efficiency of the shipping sector and reduce its emissions. This paper analyses the economic and environmental implications of two types of levy on shipping bunker fuels by means of an analytical model built on the cobweb theorem. A unit-tax per ton of fuel and an ad-valorem tax, enforced as a percentage of fuel prices, are examined. In both cases, a speed and fuel-consumption reduction equivalent to an improvement in the energy efficiency of the sector would be expected as a result of the regulation enforcement. The speed reduction in the unit-tax case depends on fuel prices and the tax amount, whereas in the ad-valorem case it relies upon the enforced tax percentage.
Both schemes lead to industry profit decline, the extent of which depend on the structure of the levy and market conditions. Since there is concern that the costs resulting from the policy will be passed from shipping companies to their customers along the supply chain, the paper dwells on how the costs arising from the enforcement of the levy will be actually allocated between ship-owners and operators, and cargo-owners. In a market characterised by high freight rates and with no or limited excess capacity, a higher percentage of the total tax amount is transferred from ship-owners to shippers. In case of a recession the opposite happens.
This paper aims to conduct an updated literature survey on the Market-Based Measures (MBMs) currently being proposed by various member states and organizations at the International Maritime Organization (IMO) or by the scientific and grey literature as a cost-effective solution to reduce greenhouse gas (GHG) emissions from ships. Τhe paper collects, summarizes, and categorizes the different proposals to provide a clear understanding of the existing discussions on the field and also identifies the areas of prior investigation in order to prevent duplication and to avoid the future discussion at the IMO to start from scratch. Relevant European Union (EU) action on MBMs is also described. Furthermore, the study identifies inconsistencies, gaps in research, conflicting studies, or unanswered questions that form challenges for the implementation of any environmental policy at a global level for shipping. Finally, by providing foundational knowledge on the topic of MBMs for shipping and by exploring inadequately investigated areas, the study addresses concrete research questions that can be investigated and resolved by the scientific and shipping community
Due to environmental and economic issues as well as the high performance of marine vessels, efficient energy using has been becoming more demanding. Also, in order to have a zero-emission ship, the utilization of a fuel cell combined with energy storage such as batteries gets more and more attention. In this work, a zero-emission hybrid energy system, including fuel cells, batteries, and cold-ironing, is employed to have an environmentally friendly vessel, and to create condition in which ship operates with high performance, both energy management and components sizing of fuel cells and batteries using real data of ferry boat and intelligent optimization method are done simultaneously. In addition, all constraints related to energy management and component sizing with the topography of the boat and electric power sources are represented and analyzed thoroughly. Ultimately, hourly energy management and component sizing for one specific day are considered in this work, and to optimize this problem, the Improved Sine Cosine Algorithm (ISCA) is utilized. According to obtained results, the proposed energy management and component sizing result in the high-performance ship which could be utilized in the marine industry.
Policy emphasis in ship design must be shifted away from global and idealized towards regional based and realistic vessel operating conditions. The present approach to reducing shipping emissions through technical standards tends to neglect how damages and abatement opportunities vary according to location and operational conditions. Since environmental policy originates in damages relating to ecosystems and jurisdictions, a three-layered approach to vessel emissions is intuitive and practical. Here, we suggest associating damages and policies with ports, coastal areas possibly defined as Emission Control Areas (ECA) as in the North Sea and the Baltic, and open seas globally. This approach offers important practical opportunities: in ports, clean fuels or even electrification is possible; in ECAs, cleaner fuels and penalties for damaging fuels are important, but so is vessel handling, such as speeds and utilization. Globally we argue that it may be desirable to allow burning very dirty fuels at high seas, due to the cost advantages, the climate cooling benefits, and the limited ecosystem impacts. We quantify the benefits and cost savings from reforming current IMO and other approaches towards environmental management with a three-layered approach, and argue it is feasible and worth considering.
Maritime shipping is the transmission belt of the global economy. It is also a major contributor to global environmental change through its under-regulated air, water and land impacts. It is puzzling that shipping is a lagging sector as it has a well-established global regulatory body—the International Maritime Organization. Drawing on original empirical evidence and archival data, we introduce a four-factor framework to investigate two main questions: why is shipping lagging in its environmental governance; and what is the potential for the International Maritime Organization to orchestrate emerging private ‘green shipping’ initiatives to achieve better ecological outcomes? Contributing to transnational governance theory, we find that conditions stalling regulatory progress include low environmental issue visibility, poor interest alignment, a broadening scope of environmental issues, and growing regulatory fragmentation and uncertainty. The paper concludes with pragmatic recommendations for the International Maritime Organization to acknowledge the regulatory difficulties and seize the opportunity to orchestrate environmental progress.
The design of emission control areas (ECAs), including ECA width and sulfur limits, plays a central role in reducing sulfur emissions from shipping. To promote sustainable shipping, we investigate an ECA design problem that considers the response of liner shipping companies to ECA designs. We propose a mathematical programming model from the regulator’s perspective to optimize the ECA width and sulfur limit, with the aim of minimizing the total sulfur emissions. Embedded within this regulator’s model, we develop an internal model from the shipping liner’s perspective to determine the detoured voyage, sailing speed, and cargo transport volume with the aim of maximizing the liner’s profit. Then, we develop a tailored hybrid algorithm to solve the proposed models based on the variable neighborhood search meta-heuristic and a proposition. We validate the effectiveness of the proposed methodology through extensive numerical experiments and conduct sensitivity analyses to investigate the effect of important ECA design parameters on the final performance. The proposed methodology is then extended to incorporate heterogeneous settings for sulfur limits, which can help regulators to improve ECA design in the future.
Shore power is an important green technology used by ports to reduce carbon emissions. This paper investigates how to design subsidy strategy for promoting the installation and utilization of shore power. However, while installation subsidies may promote the installation of SPI in ports, resulting in a reduction in ship emissions, utilization subsidies may attract more ship visits, which may increase the total emissions of a port. Therefore, subsidies for shore power utilization and installation should be optimized to minimize the cost to government (comprising the environmental costs of ship emissions, the cost of utilization or installation subsidies, and carbon taxes) and maximize the profit for ports (including profit from original and new ships, utilization and installation subsidies, and carbon taxes). Using the Stackelberg game methodology, we discuss five cases to give a comprehensive analysis of the design of different subsidy policies, including no subsidy, SPI-utilization subsidy undertaken by port, SPI-utilization subsidy undertaken by port and government, carbon emission tax policy considering SPI-utilization subsidy, and SPI-utilization and SPI-installation subsidies undertaken by port and government. Managerial insights are generated according to the theoretical analysis and numerical experiments results, which can give references to the government and port operators.
Global warming and, correspondingly, reducing CO2 emissions is one of the most challenging tasks the world faces today. The maritime industry contributed to 2.89% of the global anthropogenic CO2 emissions. To decrease this share, the International Maritime Organization (IMO) defined, among others, the goal to reduce the carbon intensity of international shipping by 40% until 2030. In this context, the short-term measures recently adopted, in the form of a technical standard (Energy Efficiency Existing Ship Index, EEXI) and a rating scheme based on an operational indicator (Carbon Intensity Indicator, CII), mark a crucial step to achieving the mentioned goal. In addition, the EU Commission has recently introduced the FuelEU Maritime Initiative limiting the annual greenhouse gas (GHG) intensity of a ship’s energy use incorporating a reduction occurring in a five-year rhythm between 2025 and 2050. The paper investigates the practical options availed to existing containerships of different sizes and technological vintages for meeting the specific EEXI, CII, and GHG intensity reduction requirements imposed by the regulations. The investigation will be based on the actual technical and operational profiles of six sample ships and will consider a set of possible compliance options including, but not limited to, engine power limitation, waste heat recovery system, variable frequency drives, and virtual arrival. The data used originates from noon reports of existing containerships provided by a European industry leader. The ship-specific CO2 emission reduction potentials required for the impact assessment result from either literature or actual data-based calculations. Financial data is used for investigating the economic impact of the reduction requirements. Conclusions drawn include an operational advantage that pre-EEDI ships enjoy when applying engine power limitation (EPL) for EEXI compliance, the occurrence of payback periods exceeding ship lifetimes, and an estimate of the effect that onshore power supply can have on complying with the FuelEU Maritime Initiative.
The shipping sector's rising greenhouse gas emissions are often considered “hard-to-abate”. Some ship-owners have recently adopted or started to consider the adoption of alternative fuels, but systematic studies of this are still lacking. We address this gap by studying how ship-owners differ in both actual and intended adoption of alternative fuels. We analyze data from a unique survey with 281 ship-owners in Norway, a major ship-owning country and center for maritime technology development, with descriptive statistics and analysis of variance. We find early adopters among large and established ship-owners in offshore, international cargo and domestic passenger shipping segments, which are often subjected to specific contractual demands for alternative fuel adoption. Laggards were typically small and young ship-owners operating in shipping segments where demands for alternative fuel adoption are weak. Our findings also suggest that firms' business strategy and financial and knowledge resources may have relevance for ship-owner's adoption of alternative fuels. Our study has implications for national and international policymaking, highlighting for example how contracting mechanisms can be an effective tool in incentivizing the adoption of alternative fuels.