The influence of directional spreading of waves is significant for wave-induced loads, wave breaking and nonlinearity of the waves. For physical model testing performed at test facilities such as the Ocean and Coastal Engineering Laboratory at Aalborg University, it is crucial to validate if the test conditions match the target sea states by measurement and analysis of the generated directional wave field. Most of the existing methods assume a double summation sea state to be present which is valid in the prototype. However, waves in the laboratory are usually generated by single summation. The current paper presents a method to analyze short-crested waves generated by the single summation method. Compared to similar methods oblique reflections are considered instead of only in-line reflections. The results show that the method successfully decomposes the incident and reflected wave fields in the time domain. Thus, for example the incident wave height distribution may be obtained. The sensitivity of the new method to additional reflective directions, noise, calibration errors and positional errors of the wave gauges was found small.
Since time-domain simulations of wave energy converters are computationally expensive, how can we analyse their dynamics and test wide ranges of design variables, without simplifying the physics involved? One possible solution is the use of General Polynomial Chaos (gPC). GPC provides computationally efficient surrogate models for partial differential equation based models, which are particularly useful for sensitivity analysis and uncertainty quantification. We demonstrate the application of gPC to study the dynamics of a wave energy converter in an operational sea-state, when there is uncertainty in the values of the stiffness and damping coefficient of the power take-off.