Mooring systems for floating wave energy converters often rely on floaters to allow for minimum restraints of the body motion in heavy. However, the inclusion of floaters also introduce possible slack-taut scenarios induced by the dynamic response of the floater in relation to the fair-lead point of the mooring. This can increase the occurrence of snap loads. The present study outlines the work to include floaters and sinks into a high-order discontinuous Galerkin model for mooring cable dynamics. Numerical simulations of a mooring leg adapted from the Waves4Power full-scale device are performed, and the results from varying the floater geometry are analyzed.
For this case the floater influence on the occurrence of snap loads was clearly evident. There is a strong correlation between floater pitch response and cable slack in the upper mooring cable. For a floater with constant buoyancy, increasing the floater height and thereby increasing the pitch inertia of the floater is shown to decrease the range of frequencies where cable slack occurs. It is illustrated that for some cases, changing floater geometry can avoid slack altogether. A careful design of the floater geometry can thus make a large difference for the dynamic load factor of the mooring system.
The paper discusses the use of CFD simulations to analyse the parametric excitation of moored, full scale wave energy converters in six degrees of freedom. We present results of VOF-RANS and VOF-Euler simulations in OpenFOAM!R for two body shapes: (i) a truncated cylinder; and (ii) a cylinder with a smooth hemispherical bottom. Flow characteristics show large differences in smoothness of flow between the hull shapes, where the smoother shape results in a larger heave response. However the increased amplitude makes it unstable and parametric pitch excitation occurs with amplitudes up to 30". The responses in surge, heave and pitch (including the transition to parametric motion) are found to be insensitive to the viscous effects. This is notable as the converters are working in resonance. The effect of viscous damping was visible in the roll motion, where the RANS simulations showed a smaller roll. However, the roll motion was found to be triggered not by wave-body interaction with the incident wave, but by reflections from the side walls. This highlights the importance of controlling the reflections in numerical wave tanks for simulations with WEC motion in six degrees of freedom.
Several large offshore wind power plants (WPP) are planned in the seas around Europe. VSC-HVDC is a suitable means of integrating such large and distant offshore WPP which need long submarine cable transmission to the onshore grid. Recent trend is to use large wind turbine generators with full scale converters to achieve an optimal operation over a wide speed range. The offshore grid then becomes very much different from the conventional power system grid, in the sense that it is connected to power electronic converters only. A model of the wind power plant with VSC-HVDC connection is developed in PSCAD for time-domain dynamic simulation. This paper presents the modeling and simulation of such a system. A single line to ground fault has been simulated and fault currents for the grounded and ungrounded offshore grid system are obtained through simulation and then compared.