Multi-phase flow meters are of huge importance to the offshore oil and gas industry. Unreliable measurements can lead to many disadvantages and even wrong decision-making. It is especially important for mature reservoirs as the gas volume fraction and water cut is increasing during the lifetime of a well. Hence, it is essential to accurately monitor the multi-phase flow of oil, water and gas inside the transportation pipelines. The objective of this review paper is to present the current trends and technologies within multi-phase flow measurements and to introduce the most promising methods based on parameters such as accuracy, footprint, safety, maintenance and calibration. Typical meters, such as tomography, gamma densitometry and virtual flow meters are described and compared based on their performance with respect to multi-phase flow measurements. Both experimental prototypes and commercial solutions are presented and evaluated. For a non-intrusive, non-invasive and inexpensive meter solution, this review paper predicts a progress for virtual flow meters in the near future. The application of multi-phase flows meters are expected to further expand in the future as fields are maturing, thus, efficient utilization of existing fields are in focus, to decide if a field is still financially profitable.
The upstream offshore multi-phase well-pipeline-riser installations are facing huge challenges related to slugging flow: An unstable flow regime where the flow rates, pressures and temperatures oscillate in the multi-phase pipelines. One typical severe slug is induced by vertical wells or risers causing the pressure to build up and hence originates the oscillating pressure and flow. There exist many negative consequences related to the severe slugging flow and thus lots of investments and effort have been put into reducing or completely eliminating the severe slug. This paper reviews in detail the state-of-the-art related to analysis, detection, dynamical modeling and elimination of the slug within the offshore oil & gas Exploration and Production (E&P) processes. Modeling of slugging flow has been used to investigate the slug characteristics and for design of anti-slug control as well, however most models require specific facility and operating data which, unfortunately, often is not available from most offshore installations. Anti-slug control has been investigated for several decades in the oil & gas industry, but many of these existing methods suffer the consequent risk of simultaneously reducing the oil & gas production. This paper concludes that slug is a well defined phenomenon, but even though it has been investigated for several decades the current anti-slug control methods still have problems related to robustness. It is predicted that slug-induced challenges will be even more severe as a consequence of the longer vertical risers caused by deep-water E&P in the future.
The current offshore oil & gas multi-phase production and transportation installations have big challenges related to the slugging flow: An unstable multi-phase flow regime where the flow rates, pressures and temperatures oscillate in the considered processes. Slug can be caused by different operating conditions and installation structures. The most severe slugs are often induced in long vertical risers or production wells, where liquid blocks gas at the riser/well base and correspondingly it causes the pressure to accumulate and hence originates the oscillating performance. There are many severe consequences to the production processes because of the slugging flow. This paper reviews some observed latest status and key challenges about slug detection, dynamical modeling and elimination of slugging flows. Mathematical modeling of slug has been used to investigate the slug mechanism and anti-slug control. Most of available models are based on mass-balance formulations, which often require sufficient data for reliable parameter tuning/identification. Slug elimination and control have been investigated for many years and there exist many solutions to eliminate the slug, but some of these methods can simultaneously reduce the oil & gas production, which is a very big concern as the production rate is the key evaluation parameter for offshore production. We conclude that the slugging flow is a well-defined phenomenon, even though this subject has been extensively investigated in the past decades, the cost-effective and optimal slug modeling and control are still open topics with many related challenges.